nomos system Forum

Normale Version: Max and min Value
Du siehst gerade eine vereinfachte Darstellung unserer Inhalte. Normale Ansicht mit richtiger Formatierung.
1000;;<KNX><SETVALUE=[CLIMA_0_1_SET_GA],[CLIMA_0_1_ACT_SET]{%+1}></KNX>;
1001;;<KNX><SETVALUE=[CLIMA_0_1_SET_GA],[CLIMA_0_1_ACT_SET]{%-1}></KNX>;
In this case I either raise or lower the current value that is set in the KNX thermostat and sent on the KNX bus.

I want to create a maximum and minimum rule for the setpoint (in this case temperature).
-For example: Max value 24 and min value 16

This is often changeable in the KNX-product, but in this case i need to block nomos from being able to set the temperature higher or lower.
Could be useful as a Max value-rule for sound or light also.

Any good ideas? Logic?
Hello,

here's my example:

mremote.csv
Code:
1000;;<SYS><SETVAR=CLIMA_0_1_ACT_SET,[CLIMA_0_1_ACT_SET]{%+1}></SYS>
1000;;<SYS><SETVAR=CLIMA_0_1_ACT_SET,[CLIMA_0_1_ACT_SET]{%-1}></SYS>

logic.csv

Code:
[LOGIC];
([CLIMA_0_1_ACT_SET] < "16");<SYS><SETVAR=CLIMA_0_1_ACT_SET,16></SYS>;;[CLIMA_0_1_ACT_SET];;
([CLIMA_0_1_ACT_SET] > "24");<SYS><SETVAR=CLIMA_0_1_ACT_SET,24></SYS>;;[CLIMA_0_1_ACT_SET];;
([CLIMA_0_1_ACT_SET] >= "16" && [CLIMA_0_1_ACT_SET] <= "24");<KNX><SETVALUE=[CLIMA_0_1_SET_GA],[CLIMA_0_1_ACT_SET]></KNX>;ONCHANGE;[CLIMA_0_1_ACT_SET];;

best regards


Thank you! I will try that!
Works Great! Thank you!

(19.05.2015 13:13)meudenbach schrieb: [ -> ]Hello,

here's my example:

mremote.csv
Code:
1000;;<SYS><SETVAR=CLIMA_0_1_ACT_SET,[CLIMA_0_1_ACT_SET]{%+1}></SYS>
1000;;<SYS><SETVAR=CLIMA_0_1_ACT_SET,[CLIMA_0_1_ACT_SET]{%-1}></SYS>

logic.csv

Code:
[LOGIC];
([CLIMA_0_1_ACT_SET] < "16");<SYS><SETVAR=CLIMA_0_1_ACT_SET,16></SYS>;;[CLIMA_0_1_ACT_SET];;
([CLIMA_0_1_ACT_SET] > "24");<SYS><SETVAR=CLIMA_0_1_ACT_SET,24></SYS>;;[CLIMA_0_1_ACT_SET];;
([CLIMA_0_1_ACT_SET] >= "16" && [CLIMA_0_1_ACT_SET] <= "24");<KNX><SETVALUE=[CLIMA_0_1_SET_GA],[CLIMA_0_1_ACT_SET]></KNX>;ONCHANGE;[CLIMA_0_1_ACT_SET];;

best regards
Referenz-URLs